Found 10 datasets matching "Powder Bed Fusion (PBF)".
-
This final report is an analysis of Powder Bed Fusion (PBF) stainless steel 316L and its suitability for Bureau of Reclamation (Reclamation) purposes. An open cube was printed using PBF additive...
Search relevance: 232.26 | Views last month: 0 -
This challenge is a follow-on from AMB2022-01 laser powder bed fusion (PBF-LB) alloy Inconel 718 in the as-built condition (no heat treatment). Eight continuum-but-miniature tensile specimens were...
Search relevance: 105.66 | Views last month: 2 -
Specimens from one build of laser powder bed fusion (PBF-L) titanium alloy (Ti-6Al-4V) were split equally into two heat treatment conditions. The first condition is a non-standard hot isostatic...
Search relevance: 102.15 | Views last month: 27 -
These sets of automated serial sectioning electron backscatter diffraction (EBSD) and X-ray computed tomography (XRCT) measurements were designed to produce spatially registered, multi-modal...
Search relevance: 99.79 | Views last month: 9 -
S&T Project ID 19085 Final Report No. ST-2021-19085-4: Analysis of 6061 Aluminum Cold Spray Material
This final report is an analysis of 6061 aluminum cold spray material and its suitability for Bureau of Reclamation (Reclamation) purposes. Cold spray Al 6061 has significantly poorer mechanical...
Search relevance: 97.81 | Views last month: 0 -
Additive manufacturing can provide an advantage over traditional manufacturing methods in situations where production of parts is limited (custom fabrication), or where parts are complex and/or...
Search relevance: 95.51 | Views last month: 0 -
This project undertook a collaboration with Oak Ridge National Laboratory to determine the feasibility and cost and to demonstrate the efficacy of additively manufactured replacements for selected...
Search relevance: 95.51 | Views last month: 0 -
One additively manufactured (AM) laser powder bed fusion (PBF-L) Inconel 625 mesoscale tensile specimen (gauge dimensions approximately 0.2mm x 0.2 mm x 1mm) was extracted from build...
Search relevance: 92.32 | Views last month: 2 -
Abstract (from the manuscript): High cycle fatigue life of laser-powder bed fusion (L-PBF) parts depends on several factors; as-built surfaces, when present, are a particular concern. This work...
Search relevance: 90.47 | Views last month: 0 -
Additively manufactured (AM) laser powder bed fusion (PBF-L) Inconel 625 blocks were built with two different scan strategies: XY and X-only. 96 tensile specimens were extracted from blocks at...
Search relevance: 75.78 | Views last month: 1
